Settings Flysky FS-i6


model
Name model (paragraph 16.02 Flysky manual)

display
Display: IntV1=pressure (53psi in this case), Tx.V1=transmitter battery voltage.

battery
RX battery setting (paragraph 16.09.02 Flysky manual).
For a warning beep when pressure is low (and when transmitter displays 0.6V), set ALARM for example to 3.0V.

fail safe
Set fail safe off (paragraph 16.09.03 Flysky manual).
With this setting the loco keeps running when the signal is temporarely lost.
Set Channel2 ON in mid position to run the loco with transmitter off
in auto mode.

mixer
Reverser on left stick (CH4) and 3 position switch (SwC):
 asign switch (paragraph 17.04 Flysky manual). Servo connected to CH4.
Extra channels 7-10 because of
10channel/10minutes firmware.

Mixer
Reverser on left stick (CH4) and 3 position switch (SwC):
  program mixer (paragraph 17.10 Flysky manual).
Servo connected to CH4.

firmware
Display showing 10channel/10minutes firmware
(paragraph 16.11 Flysky manual and link).
Take note that channel 7-10 can be used only for switch functions as the mid
and end points cannnot be set. You need a 10 channel receiver for it.



Return to Riverdale receiver page

© 2017 Riverdale Locomotives